CHANGING RADII AND LINE TYPES IN CIRCLES
The Line Type command specifies a line pattern to be
used when drawing lines. You can specify the line type,
pattern length and the mode. The line type specifies a
particular pattern, the pattern length specifies the
length of one complete line pattern, and mode specifies
how the values of the pattern length parameter are
interpreted. For more information see the PCL 5
Printer Language Technical Reference Manual.
LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT
EcE Resets the printer.
Ec%0B Enters HP-GL/2 mode.
IN; Initializes HP-GL/2 mode.
SP1; Selects pen number 1
(black). Even though
there is no physical pen,
the SP command must be
used to enable printing.
SC-75,75,-75,75,1; Sets up user scaling with
(-75,-75) as P1 and
(75.75) as P2; the "1"
parameter specifies
isotropic scaling.
PA0,0; Specifies absolute
plotting and moves to
user-unit location (0,0).
LT;CI5; Specifies a default line
type (solid) and draws a
circle with a radius of 5
user-units.
LT0;CI-12; Selects line type 0
(dotted) and draws a
circle with a radius of
12 user-units (the -sign
indicates starting at the
180 degree point).
LT1;CI19;LT2;CI-26; Selects line type 1, and
draws a circle with a
radius of 19 user-units.
then selects line type 2
and draws a circle with a
radius of 26 user-units.
LT3;CI33;LT4;CI-40; Selects line type 3,
draws a circle with a
radius of 33 user-units,
then selects line type 4
and draws a circle with a
radius of 40 user-units.
LT5;CI47;LT6;CI54; Draws the outer two
circles; the first with
line type of 5 and radius
of 47 user-units; the
second with line type of
6 and a radius of 54 user-
units.
Ec%0A Enters PCL mode.
EcE Sends a reset to end the
job and eject the page.
Copyright Hewlett-Packard Co. 1993
The information contained herein is subject to change
without notice.
Hewlett-Packard shall not be liable for incidental or
consequential damages in connection with the use of this
material.